Ubiquiti NanoStation M5

Ubiquiti NanoStation M5 (5.8GHz) Wireless Bridge & WiFi AP

Key Features

• Connect two remote locations on the one network
• Share Internet connection between buildings, remote sites, etc.
• Up to 600mW output power, 2x2 MIMO operation, 150Mbps
• Integrated AirOS web software for controlling power, bridge/AP mode, etc.
• Two units required for wireless bridge
• Includes POE injector and 240V AC adaptor.

High Speed Point-to-Point Networking

• Forget Ethernet cable, the Ubiquiti NanoStation is ideal for bridging networks or sharing broadband across a distance
• To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location
• Up to 6 remote buildings can be linked over one connection with the NanoBridge supporting AP-WDS.

• This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work
• Management of the Ubquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface.

Ready to Install

• This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments
• Signal strength indicators allow for quick and easy alignment
• For best performance the unit should be roof mounted, high and clear of obstructions, via its integrated pole mounting bracket
• The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation, and the other into the PoE Injector (which is plugged into AC power)
• This allows one cable to both power the unit and also carry network traffic
• We recommend using Cat6 Outdoor UV Shielded Cable with this unit.

A heads up!

• Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors - model ETH-SP - place one near the NanoStation and the other at the entry point to the building. The ETH-SP will absorb power surges and safely discharge them into the ground.

Need to order bulk? Please contact us for a more accurate shipping quote.